Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
Fig. 13 Brake spring installation. Legend
11.
Install brake spring compressor tool, Fig. 13, and compress spring until tool bottoms out. Ensure rear caliper guide slides freely with spring.
12.
Remove rear caliper guide tool and ensure flared end of spring cover is below circlip groove.
13.
Install circlip, then remove spring compressor. Ensure circlip is properly seated in groove.
14.
On Integra models, install adjusting nut, adjusting spring, washer and circlip into piston.
15.
On Legend models, position cup on adjuster not with grove facing bearing, then install adjuster nut, bearing, spacers wave washer and retaining
ring into piston.
16.
Apply suitable grease to new piston seal and piston boot, then install the seal and boot into caliper.
17.
Apply suitable grease to outer surface of piston, then install piston while rotating it clockwise.
18.
Install pad spring in caliper.
19.
Install caliper in reverse order of removal.
