Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
Bleeding Sequence
When bleeding the hydraulic brake system, procedures are the same as in non-ABS cars. Start with brake master cylinder and proceed to the LF wheel
cylinder, RR wheel cylinder, RF wheel cylinder and LR wheel cylinder. The only special procedures required are for the modulator, accumulator and
power unit.
Modulator Reservoir Levels
1. Fill the modulator reservoir and master cylinder reservoir to the MAX level with DOT 3 or DOT 4 brake fluid from a clean sealed container.
3. Install the ALB T-wrench on the bleeder screw. DO NOT attempt to open bleeder screw without ALB T-wrench.
3. Turn bleeder screw out one complete turn.
4. With the transmission in neutral (M/T) or park (A/T), turn the ignition key "ON" and release parking brake.
5. Verify that the power unit motor runs.
6. When fluid coming out of the bleeder nipple is free of bubbles turn the ignition "OFF".
7. Retighten bleeder screw and discard fluid.
8. Reinstall red cap on bleeder screw.
9. Turn ignition "ON" and verify the fluid coming up into the modulator reservoir is free of bubbles. If not repeat steps 6 - 9 as needed.
10
Refill reservoir and replace cap.
