Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
5. Cut off the driver's airbag connector, then strip the wire ends and connect the special tool alligator clips to them. Place the special tool
approximately thirty feet away from the airbag.
6. Connect a 12 volt battery to the tool:
-
If the green light on the tool goes on, the airbag igniter circuit is defective and cannot be deployed. Go to Damaged Airbag Special Procedure.
-
If the red light on the tool goes on, the airbag is ready to be deployed.
7. Push the tool's deployment switch. The airbag should deploy (deployment is both highly audible and visible - a loud noise and rapid inflation of
the bag, followed by slow deflation.
-
If deployment happens and the green light on the tool goes on, continue with this procedure.
-
If the airbag doesn't deploy, yet the green light goes ON, its igniter is defective.
Go to Damaged Airbag Special Procedure.
WARNING: During deployment, the airbag assembly can become hot enough to burn you.
Wait thirty minutes after deployment before touching the assembly.
8. Dispose of the complete airbag assembly. No part of it can be reused. Place it in a sturdy plastic bag and seal it securely.
CAUTION:
-
Wear a face shield and gloves when handling a deployed airbag.
