Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
-
Wash your hands and rinse them well with water after handling a deployed airbag.
9. Repeat steps 5 thru 8 for a passenger side airbag.
Triggering the Seat Belt Pretensioners:
NOTE: If an SRS car containing one or both intact seat belt pretentioners is to be entirely scrapped, the seat belt pretensioners should be triggered
while still in the car.
A pretensioner is not a salvageable part and should never be installed in another car.
1. Disconnect both the negative cable and positive cable from the battery.
2. Confirm that the special tool is functioning properly by following the check procedure on the label of the tool box, or refer to the "Deployment
Tool: Check Procedure" at the end of this article.
3. Remove the B pillar trim panel.
4. Cut off the seat belt pretensioner connector, then strip the wire ends and connect the special tool alligator clips to them as shown. Place the special
tool approximately thirty feet away from the car.
5. Buckle the seat belt, then pull out about two inches of slack, make a loop with it, and hold the loop in place with a clip as shown.
6. Connect a 12 volt battery to the tool:
-
If the green light on the tool goes on, the pretensioner igniter circuit is defective. Go to Damaged Airbag or Pretensioner Special Procedure.
