Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
-
If the red light on the tool goes on, the pretensioner is ready to trigger.
7. Push the tool's deployment switch to trigger the pretensioner igniter. The pretensioner should take up the slack in the belt (pop the clip off), and
lock the belt in its retracted position.
-
If the pretensioner works and the green light on the tool goes on, continue with this procedure.
-
If the pretensioner doesn't work, yet the green light goes ON, its igniter is defective. Go to Damaged Airbag or Pretensioner Special Procedure.
WARNING: During activation, the pretensioner can become hot enough to burn you.
Wait thirty minutes after activation before touching it.
8. Dispose of the complete pretensioner assembly. No part of it can be reused.
9. Repeat steps 3 thru 8 on the other side if that pretensioner has not been triggered.
Simultaneously Deploying Airbag(s) and Triggering Seat Belt Pretensioners:
1. Disconnect both the negative cable and positive cable from the battery.
2. Confirm that the special tool is functioning properly by following the check procedure on the label of the tool box, or refer to the "Deployment
Tool: Check Procedure" at the end of this article.
3. Disconnect the SRS main harness 18-P connector from the SRS unit.
4. Cut 8 wires at the SRS main harness connector, 4 on each side as shown. Strip the end of the wires, then twist them together to make each set of 4
wires into one.
5. Connect the alligator clips of the deployment tool to the ends of the twisted wires.
6. Buckle the seat belt, then pull out about two inches of slack, make a loop with it, and hold the loop in place with a clip as shown.
