MDX V6-3.7L (2007)
Front Door Latch: Service and Repair
Front Door Latch Replacement
NOTE: Put on gloves to protect your hands.
1. Raise the glass fully.
2. Remove the door panel and inner handle.
3. Remove the plastic cover, as needed.
4. Detach the rod fastener.
5. Disconnect the outer handle rod from the outer handle.
6. Disconnect the cylinder cable from the latch
7. Pull the glass run channel (A) away as needed, and remove the bolt, then remove the center lower channel (B) by pulling it downward.
8. Remove the screws (A, B) securing the latch (C), then remove the latch through the hole in the door. Take care not to bend the outer handle rod
(D), latch cable (E), and inner handle cable (F).
