MDX V6-3.7L (2007)
9. Remove the screw, then remove the latch protector (A) by releasing the hook (B).
10. Detach the latch cable (A) and the inner handle cable (B) from the latch (C).
11. Install the latch in the reverse order of removal, and note these items:
-
Make sure that the actuator connector is plugged in properly, and that the cylinder cable and the outer handle rod are connected securely.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.