MDX V6-3.7L (2007)
3. Remove the screws.
4. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
1. Start at the bottom edge of the door panel, release the clips with a commercially available trim pad remover.
2. Detach the upper clips.
3. Starting at the rear, pull the door panel upward.
NOTE: The inner handle cable (B) and latch cable (C) are connected to the inner handle (D). Do not pull the door panel up too far, or these
cables will be damaged.
5. While holding the door panel (A) away from the door, remove the inner handle (B) from the door panel by detaching the clips.
