MDX V6-3.7L (2007)
3. Remove the tailgate pull pocket (A).
1. Pry the hooks (B) with a trim tool.
2. Carefully pull the edge of the tailgate lower trim panel (C) just beside the tailgate pull pocket by hand, and push out the inside hooks (D).
3. Pull down the upper edge of the pocket and release the lower tabs (E).
4. With power tailgate: Disconnect the power tailgate close switch connector (F).
4. Remove the tailgate lower trim panel (A).
1. Detach the clips (B) beside the tailgate latch.
2. Pull down the panel to detach all of the clips (C).
5. Install the trim and panel in the reverse order of removal, and note these items:
-
Make sure the power tailgate close switch connector is plugged in properly.
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips into place securely.
