MDX V6-3.7L (2007)
11. Reinstall the A-pillar trim (A).
1. Insert the bottom of the trim into the dashboard(B).
2. Place the trim over the A-pillar (C), and fit its upper clip (D), the other clips (E) and the pin (F) into holes (G) in the A-pillar, then lightly push
the trim into place.
NOTE:
-
Make sure that the side curtain airbag tether (H) is below the clip.
-
Make sure the side curtain airbag isn't tucked down under the clips and ribs.
-
Apply pressure to the areas of the trim on the upper clip until these clip fittings are felt. If you push too hard, the clip will be
damaged, and it will not hold the trim properly.
-
Make sure the upper clip portions of the trim don't come off the body by tugging on the trim.
12. Reinstall the front door opening seal.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
B-Pillar Upper/Lower Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove these items:
-
Front door sill trim
-
Rear door sill trim
-
Front door opening seal, as needed
-
Rear door opening seal, as needed
2. Slide the front seat fully forward.
