MDX V6-3.7L (2007)
types of damage:
-
Any cracks or deformations in the B-pillar upper trim (B) and the upper hook (C), and any stress-whitened areas in the upper part of the
trim
-
Any cracks or deformations in the B-pillar lower trim (D), and any breakages in the part (E) fitted with the B-pillar upper trim
-
Any cracks or stress-whitened areas in the clips seating surface (F)
-
Replace any damaged parts with new ones.
-
Make sure the top of the trim overlaps with the headliner correctly.
-
Make sure the pin (G) on the front seat belt shoulder anchor adjuster (H) and the hole (I) on the back of the slider are engaged when installing
the B-pillar upper trim.
-
Make sure the trim hook is installed into the side curtain airbag B-pillar bracket securely.
-
Push the clip and hooks into place securely.
-
Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
Quarter Pillar Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Follow the quarter pillar trim installation procedure carefully; improper installation could cause the side curtain airbag to deploy improperly and
possibly cause injury.
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to scratch the trim and panels.
-
The upper clip in the quarter pillar trim (A) consists of a grommet (B) and a pin (C). The grommet expanded with the pin secures it to the body
panel (D). The projections (E) on the pin is broken during removal, so the clip must be replaced with a new one when the trim is reinstalled.
1. Remove these items:
-
Rear door opening seal, as needed
-
Tailgate weatherstrip, as needed
-
Second row seat belt lower anchor
-
Seat belt exit C-pillar cap
-
Seat belt exit D-pillar cap
-
With power tailgate: Left tailgate side trim
2. Remove the upper portion of the rear side trim panel, as needed.
