MDX V6-3.7L (2007)
5. Hit the surface of the quarter pillar trim (A) with a rubber mallet. The clip is located in the seat belt exit D-pillar cap opening. Hitting the trim
surface breaks the projections (B) on the pin (C) and pushes it into the grommet (D) and against the body (E).
NOTE: The clip must be replaced with a new one when the quarter pillar is reinstalled.
6. While pulling the upper portion of the rear side trim panel (A) back, detach the clips, then release the lower portion of the quarter pillar trim (B)
away from the body.
NOTE: The quarter pillar is still fastened with two upper clips located in the middle of it.
