MDX V6-3.7L (2007)
Seat Cover: Service and Repair
Front Seat Cover
Front Seat-back Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
-
Check the operation of the driver's seat position sensor after any of these actions.
-
Driver's seat position sensor replacement
-
Cover plate (front side of driver's seat slide rail) replacement
-
Calibrate the ODS unit after any of the these actions.
-
Front passenger's seat replacement (including any seat components)
-
Replacement of the seat weight sensors
-
After a vehicle collision
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear the seams of damage the seat covers.
-
On the passenger's seat, do not touch the OPDS sensor in the seat-back pad, and keep it away from oil. Oil can corrode the sensor causing it to fail.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the front seat.
2. Remove the seat-back.
3. Detach the clips, release the hooks (A) by pulling the bottom of the back panel (B) back, then gently pull down the panel to release the hooks (C)
from the seat-back frame, and remove the panel.
NOTE: Detach the clips and hooks in the numbered sequence as shown.
