MDX V6-3.7L (2007)
Brake Hose/Line: Service and Repair
Brake Hose Replacement
NOTE:
^
Before reassembling, check that all parts are free of dirt and other foreign particles.
^
Replace parts with new ones whenever specified to do so.
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
Removal - Front
1. Remove the front wheel.
2. Disconnect the brake line (A) from the brake hose (B), then remove the brake hose clip (C).
3. Remove the banjo bolt (A), and disconnect the brake hose (8) from the caliper.
4. Remove the brake hose mounting bolt (C), then remove the brake hose.
Installation - Front
1. Install the brake hose (A) with the mounting bolt (B).
2. Connect the brake hose to the caliper with the banjo bolt (C) and new sealing washers (D).
3. Install a new brake hose clip (A) to the brake hose (B) on the bracket, then connect the brake line (C). Do not twist the brake hose.
