MDX V6-3.7L (2007)
4. After installing the brake hose, bleed the brake system.
5. Do the following checks:
^
Check the brake hose and line joint for leaks, and tighten if necessary.
^
Check the brake hoses for interference and twisting.
6. Clean the mating surface of the brake disc and the inside of the wheel, then install the front wheel.
Removal - Rear
1. Remove the rear wheel.
2. Disconnect the brake lines (A) from the brake hoses (B), then remove the brake hose clips (C).
3. Remove the front side brake hose (D).
4. Remove the banjo bolt (A), and disconnect the brake hose from the caliper.
5. Remove the rear side brake hose (B).
Installation - Rear
1. Connect the rear side brake hose to the caliper with the banjo bolt (A) and new sealing washers (B).
