MDX V6-3.7L (2007)
3. Connect the parking brake cable (A) to the parking brake lever (B). Apply Plastilube # 2 grease to the cable contact surface (C) on the backing
plate.
4. Apply a thin coat of Plastilube # 2 grease to the shoe ends and strut ends (A), sliding surfaces (B), and opposite edges of the parking brake shoe
(C) as shown. Wipe off any excess. Keep the grease off the brake linings.
5. Install the tension pin (A), the retainer spring (B), and the retainer (C) on the rearward brake shoe (D). Make sure the tension pin does not contact
the parking brake lever.
6. Install connecting rods A and B on the adjuster nut (C).
NOTE:
^
Clean the threaded portions of connecting rod A and the sliding surface of connecting rod B, then coat them with rubber grease.
^
Shorten connecting rod A by fully turning the adjuster nut.