MDX V6-3.7L (2007)
Crankshaft: Service and Repair
Crankshaft and Piston Removal
Crankshaft and Piston Removal
1. Remove the engine assembly.
2. Remove the transmission.
3. Remove the drive plate.
4. Remove the cylinder heads.
5. Remove the crankshaft position (CKP) sensor.
6. Remove the timing belt drive pulley from the crankshaft.
7. Remove the oil pan.
8. Remove the engine block and cover.
9. Remove the rocker arm oil control solenoid/oil filter assembly.
10. Remove the oil screen (A), baffle plate (B), and oil pump (C).
11. Remove the connecting rod caps after setting the crank pin at bottom dead center (BDC) for each cylinder. Remove the piston/connecting rod