MDX V6-3.7L (2007)
Valve Cover: Service and Repair
Cylinder Head Cover Installation
Cylinder Head Cover Installation
1. Check the spark plug seals and head cover gasket for damage and deterioration. If any seal or gasket is damaged, replace it.
2. Thoroughly clean the head cover gasket and the groove of the cylinder cover.
3. Install the head cover gasket (A) in the groove of the cylinder head cover (B). Make sure the head cover gasket is seated securely.
4. Clean the head cover contacting surfaces with a shop towel.
5. Set the spark plug seals (A) on the spark plug tubes, and install the cylinder head cover (B).
6. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
7. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12N-m (1.2 kgf-m, 8.7 lbf-ft).
