MDX V6-3.7L (2007)
8. Install the ATF filler bolt (B) and a new sealing washer (C).
9. Remove the dipstick (A).
10. Make sure the fluid level is between the upper mark (B) and lower mark (C) on the dipstick.
11. Install the transmission undercover.
12. If the maintenance minder required to replace the ATF, reset the maintenance minder and this procedure is complete. If the maintenance minder
did not require to replace the ATF, go to step 10 and reset the ATF life with the HDS.
13. Connect the HDS to the DLC (A) and go to the BODY ELECTRICAL. If the HDS does not communicate with the PCM, troubleshoot the DLC
circuit.
