MDX V6-3.7L (2007)
8. Remove the locknut (A), locknut plate (B), and fuel tank unit (C).
Installation
1. Install a new base gasket (A) and locknut plate (B) on the fuel tank (C).
2. Insert the fuel tank unit (D) into the fuel tank. Be careful not to bend the fuel gauge sending unit.
3. Align the marks (E) on the tank and the fuel tank unit, then tighten a new locknut (F) by hand.
NOTE:
-
After tightening, make sure the marks are aligned. Check the circumference of the base gasket visually or by hand and be sure that it is not
pinched.
-
Do not coat the base gasket with the engine oil.
-
After installation, check the base gasket visually or by hand to be sure it is not pinched.
