MDX V6-3.7L (2007)
^ Connect the receiver connectors.
12. Reinstall the driver's and front passenger's seat belt retractor protectors and the retractors:
^ Torque the retractor upper mounting bolts to 9.8 N.m (7.2 lb-ft).
^ Torque the retractor lower mounting bolts to 32 N.m (24 lb-ft).
^ Connect the retractor connectors.
13. Reinstall the under-dash fuse/relay box, and connect the connectors.
14. Reinstall the center console:
^
Torque the console front mounting bolts to 22 N.m (16 lb-if).
^
Torque the console rear mounting bolts to 9.8 N.m (7.2 lb-ft).
^
Torque the rear blower motor relay mounting bolt and the ground bolt to 9.8 N.m (7.2 lb-ft).
^
Connect the parking pin shift connector and the shift lock solenoid connector.
15. Reinstall the left and right rear side trim panels.
16. Reinstall the left and right quarter pillar trim. The four upper clips on each quarter pillar trim must be replaced.
17. Reinstall the left and right B-pillar lower trim.
18. Reinstall the carpet:
^
Do not wrinkle or twist the carpet.
^
Make sure the seat harness connectors are routed correctly.
^
Slip the slits in the carpet over the heater ducts at the second row and third row seats.
^
Properly slip the carpet under the center console, under the B-pillar lower trims, and under the rear side trim panels.
^
Torque the footrest nut to 6 N.m (4 lb-ft).
19. Reinstall the steering joint cover.
20. Reinstall the dashboard undercovers:
^
On the driver's side, attach the harness clip, connect the ambient light connector, and connect the footwell light connector.
^
On the passengers side, connect the ambient light connector, and the footwell light connector.
21. Reinstall the kick panels.
22. Reinstall the front and rear door sill trims.
23. Reinstall the seats:
^
Connect power seat connectors and the side airbag connectors to the connectors on the front seats.
^
Connect ODS connector to the connector on the front passenger's seat.
^
Apply Hondalock 2 Thread lock to the seat bolts, then reinstall the bolts, and torque them to 47 N.m (35 lb-if)
^
Torque the front seat belt lower anchor bolts to 32 N.m (24 lb-ft).
24. Insert these parts of the floor wire harness into their openings in the passenger compartment, then push them through to the outside of the vehicle:
^
Middle of floor: EVAP canister shut valve connector and FTP sensor connector
