MDX V6-3.7L (2007)
- Under-Dash Fuse/Relay Box Removal and Installation
- Front Seat Belt Replacement
- AcuraLink Control Unit (XM Receiver) Removal/Installation
- SH-AWD Control Unit Replacement
- Active Damper Control Unit Replacement
- Cargo Area Light Test/Replacement
Floor Wire Harness Removal
NOTE:
Refer to the floor wire harness chart/illustration as needed.
1. Disconnect the negative cable from the battery, and wait at least 3 minutes.
2. Raise the vehicle on a lift, then remove the right front wheel and the rear wheels.
3. Remove the right front inner fender.
4. Inside the fender, disconnect the rear washer hose at the T- fitting, and plug both ends of the hose.
5. Push the end of the rear washer hose and its grommet into the passenger compartment.
NOTE:
The rear washer hose is attached to the main wire bundle of the floor wire harness. The new floor wire harness comes with the washer hose
already attached.