MDX V6-3.7L (2007)
^
Rear of floor: C613 (23P) floor wire harness connector and grommet
^
Rear fenders: Rear TPMS initiator connectors
^
Right front fender: rear washer hose and grommet
25. Raise the vehicle on a lift.
26. Connect the EVAP canister shut valve connector and the FTP sensor connector to the EVAP canister. Make sure the wire harness grommet is
securely fitted to the vehicle body.
27. Reinstall the EVAP canister cover, and torque the cover bolts to 22 N.m (16 lb-ft)
28. Connect the C613 (23P) floor wire harness connector to the rear subframe wire harness connector. Make sure the wire harness grommet is securely
fitted to the vehicle body.
29. Connect the rear TPMS initiator connectors. Make sure the wire harness grommet is securely fitted to the vehicle body.
30. Reinstall the rear fender covers:
^ Torque the wheel arch bolts to 9.8 N.m (7.2 lb-ft).
^ Replace any damaged mounting clips.
31. Attach the new rear washer hose to the existing hose inside the right front fender. Make sure the hose grommet is securely fitted to the vehicle body.
32. Reinstall the right front fender cover:
^ Torque the front lower bolt to 9.8 N.m (7.2 lb-ft).
^ Replace any damaged mounting clips.
33. Reinstall the right front inner fender:
34. Reinstall the wheels.
35. Reconnect the negative cable to the battery.
36. Test-drive the vehicle, and make sure that all vehicle systems and controls are working properly.
37. Use the HDS to check for DTCs, and clear any that you find.
Disclaimer
