MDX V6-3.7L (2007)
6. If necessary, center the cable reel (New replacement cable reels come centered.). Do this by first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (about three turns) until the arrow mark (A) on the cable reel label points straight up.
7. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown, and install the steering wheel on to the steering column shaft, making
sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel
or steering column shaft when installing the steering wheel.
8. Install a new steering wheel bolt (A), then reconnect the connectors.
9. Install the driver's airbag.
10. Reconnect the negative cable to the battery.
11. After installing the cable reel, confirm proper system operation:
-
Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
-
After the SRS indicator has turned off, turn the steering wheel fully left and right to confirm the SRS indicator does not come on.
-
Make sure the horn works.
-
Make sure the cruise control buttons work.
-
Make sure the steering wheel audio controls works.
-
Make sure the INFO/SEL buttons works.
