MDX V6-3.7L (2007)
18. Push the locknut against the transmission housing to seat the transmission range switch into the Control shaft, and tighten the locknut (A) to 12
N-m (1.2 kgf-m, 8.7 lbf-ft) while holding the control shaft (B) with a 6.0 mm wrench (C) then bend the lock tabs (D) of the lock washer against
the locknut.
19. Tighten the bolts (E) to 12 N-m (1.2 kgf-m, 8.7 lbf-ft) securing the transmission range switch.
20. Install the control lever (A) spring washer (B) lock washer (C) and locknut (D) on the control shaft (E).
21. Check the connectors for rust, dirt, or oil, clean, then connect the connector securely.
