MDX V6-3.7L (2007)
Damper/Spring (With Active Damper System)
NOTE:
^
When compressing the damper spring, use a commercially available strut spring compressor (Branick MST-580A or Model 7200, or equivalent)
according to the manufacturer's instructions.
^
Except where called out, the illustrations shown are without active damper system.
Disassembly
1. Compress the damper spring, then remove the nut (A) while holding the damper shaft with a hex wrench or TORX wrench (B). Do not compress
the damper spring more than necessary to remove the nut.