MDX V6-3.7L (2007)
4. Slowly raise the floor jack until you can align the bolt hole with the holes in the lower arm B and the knuckle and install the new flange bolts.
5. Install the stabilizer link on the lower arm B, then loosely install the new flange nut (A).
6. Raise the floor jack until the hole in the trailing arm aligns with the hole in the damper.
7. Tighten the flange bolts to the specified torque values.
8. Tighten the flange nut to the specified torque values, while holding the respective joint pin with a hex wrench.
9. Install the muffler hanger (A).
10. Clean the mating surface of the brake disc/drum and the inside of the wheel, then install the rear wheel.
11. Check the wheel alignment, and adjust it if necessary.
