MDX V6-3.7L (2007)
7. Install the power steering fluid hose clamp on the bracket.
8. Slide the ATF cooler inlet hose over the ATF cooler line until the hose end contacts with the bulge, and secure the hose with the clip at 6-8 mm
(0.2-0.3 in.) from the hose end.
9. Slide the ATF cooler outlet hose over the ATF cooler line until the hose end contacts with the bulge, and secure the hose with the clip at 2-4 mm
(0.1-0.2 in.) from the hose end.
10. Secure the cooler hoses with the hose clamps at the marks on the hoses.
11. Install the hose clamp at the mark.
12. Install the front bumper and install the front bulkhead cover.
13. Install the splash shield and transmission undercover.
14. Check the ATF level.
