MDX V6-3.7L (2007)
23. Stake the locknut tab (A) into the groove in the input shaft.
24. Apply ATF to the tapered roller bearings, then Install the ring gear assembly (A) bearing outer races (B) 75 mm shim (C) and the 8 x 14 mm
dowel pins (D).
25. Remove the dirt and oil from the sealing surfaces. Apply liquid gasket (P/N08718-0001) to the sealing surface. Make sure you seal the entire
circumference of the bolt holes to prevent oil leakage.
NOTE:
-
You must assemble the housings within do in 5 minutes after applying the liquid gasket. If not, the sealing surface must be cleaned, and the
liquid gasket reapplied.
-
Allow it to cure at least 30 minutes after assembly before filling the differential with fluid.
-
Remove the overflowing liquid gasket, when joining side case.