MDX V6-3471cc 3.5L (2002)
^
If a creaking or ticking noise comes from the dashboard or front damper area, go to the appropriate REPAIR PROCEDURE.
^
If the noise is not a creaking or ticking from the dashboard or front damper area, continue troubleshooting.
REPAIR PROCEDURE A
2002 MDX: From VIN 2HNYD1...2H523466 thru 2HNYD1...2H532574
1.
Remove the appropriate front damper/spring assembly. Refer to page 18-18 of the 2001-02 MDX Service Manual.
2.
While wearing eye protection, use an angle grinder with sandpaper to remove any spot weld burrs that are raised above the surface of the damper
mounting area. Grind down the burrs flush with the surrounding area. Grinding off more material than necessary may create an uneven surface and
could result in additional noise.
NOTE:
The exact location of spot weld burrs may vary. Be sure to check the damper mounting area completely.
3.
Prepare and refinish the bare metal to prevent rust. Refer to the appropriate body repair manual.
4.
Clean the surface of the damper mounting base with isopropyl alcohol.
5.
Install three self-adhesive shims to the damper mounting base as shown. Position the shims so the edge of the shim is slightly rolled over the edge
of the damper mounting base.
6.
Reinstall the front damper/spring assembly. Refer to page 18-20 of the 2001-02 MDX Service Manual.
7.
Check the front wheel alignment, and adjust as necessary.
8.
Test-drive the vehicle over bumps to make sure the noise is gone.
REPAIR PROCEDURE B
2001 MDX: All
