MDX V6-3471cc 3.5L (2002)
Paint: Service and Repair
Top Coating
Top Coating
1. Masking
Mask the area surrounding the damage to prevent over spray from the top coat.
Use masking tape and paper.
2. Spraying top coat enamel / clear coat
Spray 2-3 double coat until the intermediate coat is fully covered.
-
Use a 2-part polyester urethane top coat enamel and a spray gun.
-
Mix the top coat enamel with the additive and solvent, and in the correct ratio.
-
Follow the top coat manufacturer's instructions.
Drying
After spraying the top coat enamel, allow it to air dry, then force dry it with infrared lamps or an industrial dryer.
NOTE: Follow the top coat manufacturer's instructions for drying time.
Spraying clear coat
Spray the top coat clear evenly over the surface of the top coat enamel. Do not try to cover the surface with one heavy coat.
Drying
After spraying the clear coat, allow it to dry for 10 minutes, then force dry it with infrared lamps or an industrial dryer.
NOTE: Follow the top coat manufacturer's instructions for drying times.
3. Polishing / buffing
Check that the clear coat has dried thoroughly.
The clear coat is cooled.
