MDX V6-3471cc 3.5L (2002)
-1. Any adhesion or roughness on the top coat should be wet sanded and repaired.
Use #1200-#2000 sandpaper and a crystal block.
-2. Polish all roughness caused by sanding.
NOTE: Clear the top coat surface frequently so you don't damage the clear coat with the polishing particles.
Use a buffing towel, buffing wool, and compound.
-3. Finishes up with buffing.
NOTE:
-
Do not use a power buffer.
-
Don't polish top much; use light hand pressure.
Use a buffing sponge, fine compound, very fine compound, then ultra fine compound.
-4. After buffing, remove the masking paper and tape, and thoroughly wash the entire vehicle.