acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Power Seat Motor Position Sensor|Locations > < All Technical Service Bulletins for Power Seat Motor Position Sensor:|03-019|Page 947
Page 4
background image

15.

Reinstall the seat into the vehicle, and plug in the connectors.

16.

Apply Hondalock 2 thread lock to the four seat mounting bolts, and install the bolts. Torque the bolts to 47 N.m (35 lb-ft).

17.

Reconnect the negative cable to the battery.

18.

Test the operation of the driver's seat slide by moving the seat forward and backward.

19.

When starting the vehicle, make sure the SRS indicator comes on and goes off. This confirms that there are no SRS DTCs set.

20.

Do the idle learn procedure:

^

Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are off.

^

Start the engine, and let it warm up to its normal operating temperature (the cooling fans cycle twice).

^

Let the engine idle (throttle fully closed and all electrical items off) for 10 minutes.

*21. For 2003-06 MDXs only: Do the power window reset procedure:*

^

Turn the ignition switch off, then back to ON (II).

^

Make sure the driver's window is fully closed.

^

Push down on the window switch until the window goes all the way down.

^

Pull up on the window switch until the window goes all the way up, then hold the switch for at least 2 more seconds.

22.

Enter the anti-theft codes for the audio and navigation system, and enter the audio presets.

*23. Set the clock, except on 2001-02 and 2005-06 models with the navigation system.*

Disclaimer

Power Seat Motor Position Sensor|Locations > < All Technical Service Bulletins for Power Seat Motor Position Sensor:|03-019|Page 947