MDX V6-3471cc 3.5L (2002)
8.
Remove the four TORX-head seat track mounting bolts.
9.
Separate the seat from the track, and pull the track out so you have enough clearance to remove the seat track synchronizer cable without damaging
the cable. Remove the cable.
NOTE:
Do not damage the cable; it is not available separately.
10.
Remove the seat slide position sensor, and replace it with a new one.
11.
Pull on the seat track so you have enough clearance to reinstall the synchronizer cable without damaging the cable. Reinstall the cable.
12.
Reinstall the seat frame to the track. Reinstall the four TORX bolts, and torque the bolts to 8 to 10 Nm (6 to 7 lb-ft).
13.
Reinstall the front cover and the center cover.
14.
Reinstall the seat riser, and torque the four nuts to 47 N.m (35 lb-ft).
