MDX V6-3471cc 3.5L (2002)
1. Position lower arm B. install the adjusting bolt (C), adjusting collar (D), and loosely install the self-locking nut (E).
2. Install the spring (F), and upper spring seat (G). Align the bottom of the spring and the lower spring seat (H) with lower arm B as shown.
3. Place a floor jack at the connecting point of lower arm B and the knuckle.
4. Align the bolt holes of lower arm B and the knuckle, and install the flange bolt.
5. Raise the rear suspension with a floor jack to load the vehicle weight.
6. Tighten the flange bolt (A) and self-locking nut on the adjusting bolt to the specified torque values.
7. Install the wheel sensor harness (B).
8. Install the rear wheels.
9. Check the rear wheel alignment, and adjust it if necessary.
