MDX V6-3471cc 3.5L (2002)
4. Compress the damper assembly by hand, and check for smooth operation through a full stroke, both compression and extension. The damper
should extend in a smooth, continuous motion when the compression is released. If it does not (no compression or no extension), the gas is
leaking, and the damper should be replaced.
5. Check for oil leaks, abnormal noises, or binding during these tests.
Reassembly
1. Install the damper unit on a commercially available strut spring compressor (A).
2. Assemble the damper in the reverse order of removal except for the washer and self-locking nut. Align the bottom of the damper spring and the
spring lower seat (B).
3. Compress the damper spring.
4. Install the damper mounting washer (A) and a new self-locking nut (B).
5. Hold the damper rod using a hex wrench (C), and tighten the self-locking nut.
Installation
