MDX V6-3471cc 3.5L (2002)
Suspension Spring ( Coil / Leaf ): Service and Repair
Damper Replacement
Removal
1. Raise the rear of the vehicle, and make sure it is securely supported. Remove the rear wheels.
2. Place a floor jack at the connecting point of lower arm B and the knuckle.
3. Remove the flange bolt (A) from the body.
4. Remove the self-locking nut (B) and washer from the knuckle.
5. Compress the damper (C) by hand, and remove it from the vehicle.
Inspection
1. Push on the damper by hand as shown.
2. Check for smooth operation through a full stroke, both compression and extension. The damper should extend in a smooth, continuous motion
when the compression is released. If it does not (no compression or no extension), the gas is leaking, and the damper should be replaced.
3. Check for oil leaks, abnormal noises, or binding during these tests.
Installation
1. Place a floor jack at the connecting point of lower arm B and the knuckle.
2. Compress the damper (A) by hand, and move it into position. Loosely install the flange bolt (B), washer, and self-locking nut (C).
3. Raise the rear suspension with a floor jack to load the vehicle weight.
