MDX V6-3471cc 3.5L (2002)
4. Remove the three flange bolts (A) and the wheel sensor harness (C) from lower arm B. Do not disconnect the wheel sensor connector.
5. Remove the flange bolt (D) that connects lower arm B and the knuckle.
6. Lower the floor jack gradually.
7. Remove the spring (A), upper spring seat (B), and lower spring seat (C).
8. Remove the flange bolt (D) and bump stop (E).
Installation
1. Install the bump stop (A), and tighten the flange bolt (C) to the specified torque.
2. Install the upper spring seat (D) and spring (E). Align the bottom of the spring and the lower spring seat (F) with lower arm B as shown.
3. Place a floor jack at the connecting point of lower arm B and the knuckle.
