MDX V6-3471cc 3.5L (2002)
Idler Gear Shaft: Service and Repair
Transmission Housing Bearing Replacement
Special Tools Required
-
Driver 07749-0010000
-
Attachment, 72 x 75 mm 07746-0010600
1. Remove the transfer output shaft bearing (A) from the transmission housing (B). If the bearing is press-fitted, remove the bearing by heating the
housing to about 212°F (100°C) with a heat gun (C). Do not heat the housing more than 212°F (100°C).
2. Install the new bearing in the housing, use the special tools if the bearing is press-fitted.
3. Select the 24 mm thrust shim.
Transfer Output Shaft Bearing Replacement
Special Tools Required
-
Driver 40 mm I.D.7746-0030100
-
Attachment, 35 mm I.D.7746-0030400
1. Remove the transfer output shaft bearing (A) with a universal two-jaw puller (B) and a bearing separator (C). Place a shaft protector (D) between
the transfer output shaft and a puller to prevent damaging the shaft.