NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4294004.png)
20. Application of Top Coat Spraying/drying
NOTE: Black painting of roof panel.
-
Prior to putting the car in the painting booth, thoroughly clean the interior and spray water over the floor. Be careful about air-blow dust and
dirt.
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Air dry and degrease the surface before spraying the paint. Also clean the surface with a tack cloth.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray color matched top coat over the prepared surface. Apply 2-3 coats in two directions until the intermediate coat 2 is fully covered.
NOTE: For application of the top coat, refer to Step 16 "Application of Intermediate Coat 2."
Solid color: Color enamel + color clear coat
Metallic color: Metallic enamel + clear coat
Pearl color: Pearl enamel + clear coat
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do no touch parts being dried.
-
After spraying, allow the paint to settle for about 10 minutes, then force dry with an infrared lamp.
NOTE: Follow the paint manufacturer's instructions.
21. Polishing/buffing
-
Let the paint dry gradually, then polish the surface carefully using a polishing compound and sponge buff.
-
To remove lint or dirt, wet sand the surface with #2000 paper or finer first, then polish with compound.
NOTE: Polish all roughness caused by sanding thoroughly. To do this, first polish with very fine compound, then with ultra fine compound.
-
After polishing, remove the masking paper and tape and wash the entire vehicle thoroughly.
