NSX-T V6-3.2L DOHC (VTEC) (1997)
NOTE:
-
Avoid heavy application of paint at one time.
-
Allow each coat to flash-off before applying another coat.
12. Drying and sanding
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
-
Air dry for 10-15 minutes before force drying.
NOTE:
-
Follow the paint manufacturer's instructions.
-
Use constant care while force drying to prevent deformation.
-
After drying, wet sand the top coating area with #600 - #800 sandpaper.
NOTE: Use a rubber block and sand flat and smooth.
-
Clean and air blow
13. Masking
Mask the surface around the repair to keep over spray off.
NOTE:
-
Mask as much of the surface as possible.
-
Use masking paper which is free of fiber dust. Use of polyethylene sheet is recommended.
14. Surface discharging
NOTE: Wear safety goggles, rubber gloves and face mask. Follow the manufacturer's instructions.
-
By alkaline degreasing agent/surface active agent.
1. Degrease with alkaline degreasing agent and rinse well with water.
Degreasing agent: LIDOLIN 24 (Nippon Paint) or equivalent.
2. Treat with surface active agent and rinse well with cold or hot water.
Surface active agent: LIDOSOLE 501 (Nippon Paint) or equivalent.
-
By surface discharger
Use a surface discharger to negatively ionize the surface to be painted.