NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Fill the gun's paint cup with the primer. Use a strainer when pouring the primer into the cup.
-
Primer should never be applied to a dirty or greasy surface. Before spraying, blow dust and dirt off the surface and clean with wax and grease
remover.
(Method of spraying)
-
Do not try to cover the surface with one heavy coat. Apply several thin coats.
NOTE:
-
Spray coat 4 - 5 coats to get 20 microns of thickness, as one coat deposits 5-7 microns.
-
Spray the primer at 250-300 kPa (2.5-3.0 kg/sq.cm, 35.6-42.7 psi) pressure. Spraying with improper air pressure will cause imperfections.
-
Open the gun 3-4 turns.
-
Wipe up unwanted primer immediately with thinner.
5. Cleaning spray gun
-
After spraying, be sure to clean the spray gun thoroughly with thinner or solvent.
-
The gun will be permanently clogged if the primer is allowed to dry.
6. Drying
-
After spraying the chipping guard primer, air-dry for 7-10 minutes to evaporate the thinner in the primer. Then dry it with infrared lamps at
176 degrees F(80 degrees C) for 30-40 minutes.
NOTE: Insufficient baking may cause pinholes if the primer coat is too thick.
-
The temperature lamps and drying time recommendations should be followed closely.
NOTE: The upper line of time shows specifications for High Primer Surfacer 2C, and the lower line Auto Primer Surfacer Mighty.
7. Intermediate and Top coating
-
Sand the chipping guard primer film with #280- #400 sandpaper.
-
Follow the intermediate/top coating procedures .