NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Before setting the rear bulkhead center, clean the welding sections of the rear bulkhead center and body using a stainless steel wire brush.
-
Clamp the front floor and inner panel with the vise-grips and pliers.
-
Check the rear bulkhead center position using the body dimensional drawings .
6. Weld the clamped sections for temporary installation.
WARNING: To prevent eye injury and burns when welding, wear approved welding helmet, gloves and safety shoes.
Set the rear window and rear hatch, check for proper rear bulkhead installation.
NSX-T (open top):
NOTE: Use of a roof panel positioning jig is recommended.
-
Install the roof panel positioning jig as shown.
-
Check the roof rail and rear bulkhead center position.
7. Perform the main welding.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.