NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4367009.png)
-
Remove the trunk front cross member.
-
Cut the trunk front gutter and trunk front panel.
NOTE: Check the reshaped parts for cracks.
8. Keep the body level.
Jack up the body and place safety stands at the four designated of the side sills.
9. Set the new rear side frame and trunk front panel.
-
Drill the 8-10 mm (5/16"-3/8") plug weld holes in the welding flange of the new rear side frame.
-
Remove the undercoat from the welding section of the rear side frame, and expose the aluminum alloy base using a disc sander.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Remove the paint film from the welding section of the body and clean oil spots with a shop towel soaked with wax and grease remover.
-
Before setting the rear side frame, remove the oxide film from the welding sections of the rear side frame and body using a stainless steel wire
brush.
-
Tighten the rear side frame against the side sill, rear bulkhead center and rear floor cross member.
