NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Place the jack under the rear side frame and support it, and measure the positions for temporary attachment.
-
Clamp the rear floor and rear panel.
-
Check the rear side frame and rear damper base positions using the body dimensional drawings.
NOTE: Use of positioning jig as shown is recommend.
10. Tack weld the rear side frame and trunk front panel.
Coupe:
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
NOTE: Use of positioning jig as shown is recommend.
11. Set the new side panel.
-
Align the new part with the top cut section, then cut it with handsaw.
-
Clamp the side panel in place with vise-grips.
-
Temporarily install the door, rear fender, trunk lid and rear bumper, and check for clearance and level differences.