NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-4367011.png)
NOTE: Check for flushness of the front fender, door, and rear fender, and check for smooth body line of car.
-
Remove the new side panel.
12. Perform the main welding.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, perform the trial welding following the welder manufacturer's instructions.
-
Remove the oxide film from the welding section using a stainless steel wire brush.
-
The applicable welding methods are MIG welding, plug welding, and fillet welding.
-
Check the welding sections for cracks.
-
Weld the side sill
