NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Weld the side upper member.
NSX-T (open top):
-
Weld the center pillar lower reinforcement.
-
Weld the rear frame lower extension.
13. Weld the new side panel , new rear floor and rear panel.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, remove the oxide film from the welding sections using a stainless steel wire brush.
-
The applicable welding methods are MIG welding, plug welding, and fillet welding.
-
Attach a tab to the butt welding section as shown and weld.