NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Before setting the trunk front panel and trunk side gutter, remove the oxide film from the welding section of the trunk front panel and trunk
side gutter, and body using a stainless steel wire brush.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Remove the part film from the welding section of the body using a disc sander and clean oil contamination with wax and grease remover.
-
Before setting the trunk front panel and trunk side gutter, remove the oxide film from the welding section or the trunk front panel and trunk
side gutter, and body using a steel wire brush.
-
Clamp the trunk front panel and trunk side gutter in place with vise-grips.
-
Check that the rear side frame is parallel at the right and left.
-
Set the rear floor and rear panel.
-
Check the trunk front panel position using the body dimensional drawings.
5. Tack weld the trunk front panel and trunk side gutter.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety hose.
-
Open and close the rear hatch and trunk lid to check for proper installation.
6. Perform the main welding
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, perform the trial welding following the welder manufacturer's instructions.
-
Remove the oxide film from the welding sections using a stainless steel wire brush.
-
The applicable welding methods are MIG/plug welding and fillet welding.