NSX-T V6-3.2L DOHC (VTEC) (1997)
1. After wiping down the camshaft and journals in the cylinder head, lubricate both surfaces and install the camshafts and rubber caps.
NOTE: Apply liquid gasket around the rubber cap.
2. Turn the camshaft until its keyway is facing up. (No. 1 cylinder TDC).
3. Set a new O-ring and a dowel pin in the oil passage of the No. 1 camshaft holder.
4. Install the camshaft seals with the open side (spring) facing in.
-
Lubricate cam lobes after reassembly.
5. Apply liquid gasket to the head mating surfaces of the No. 1 and the No. 4 camshaft holders.
-
Apply liquid gasket to the shaded areas.