acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor] > < MIL Never Comes on|Page 3208
Page 3
background image

NOTE:
-

When there is no Diagnostic Trouble Code (DTC) stored, the MIL will stay on if the SCS service connector is connected and the ignition switch is
on.

-

If this symptom is intermittent, check for:
-

A loose ACG(S) (20 A) fuse in the engine compartment fuse/relay box

-

A loose No. 2 FUEL PUMP SRS2 (15 A) fuse in the under-dash fuse box

-

An intermittent short in the wire between the ECM (C5) and the service check connector

-

An intermittent open in the wires between the ECM (A26, B14) and the service check connector

-

An intermittent short in the wire between the ECM (A7) and the gauge assembly

-

An intermittent short in the wire between the ECM (F1) and the MAP sensor, accelerator position sensor

-

An intermittent short in the wire between the ECM (D10) and the TP sensor, EGR valve lift sensor

-

An intermittent short in the wire between the ECM (F14) and accelerator position sensor 

-

See the OBD II scan tool or Honda PGM Tester user's manuals for specific operating instructions.

Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor] > < MIL Never Comes on|Page 3208